Invacare 6375, User Manual

Fixed Wheel Leg Extensions

2

Part No 1167434

3 Installation

3.1

Installing Glide Tips on Rear Leg Extensions

1.

Press the snap button on the walker frame and 

remove the existing rear leg extension.

2.

Firmly grasp the rear leg extension remove the 

existing rubber tip from the leg extension.

3.

Insert the new glide tip into the leg extension 

tube.

4.

Gently tap the glide tip on a hard surface to seat 

it into position.

5.

Press the snap button on the walker frame and 

slide the rear leg extension to the proper 

height adjustment. Allow the snap button to 

engage into the height adjustment hole.

6.

Repeat STEPS 1-5 to install a glide tip onto the 

opposite rear leg extension.

FIGURE 1   

Installing Glide Tips on Rear Leg 

Extensions



ACCESSORIES WARNING

Invacare products are specifically designed and manufactured for use in conjunction with 

Invacare accessories. Accessories designed by other manufacturers have not been tested by 

Invacare and are not recommended for use with Invacare products.



STABILITY WARNINGS AND GUIDELINES

•   Glide tips on rear leg extensions should only be used with front wheel attachments.
•   Check to make sure that the rubber tips and/or plastic glide tips are not ripped, worn or 

missing. Replace them before using the walker.

•   Glide tips are not recommended for use on rough surfaces including surfaces that may be 

experienced outdoors.

•   Glide tips are used on rear leg extensions ONLY to allow the walker to roll easily over 

indoor carpeted areas without the need to lift the walker off of the ground.

•   Glide tips do not grip the floor the way rubber tips grip flooring, therefore, extra caution 

should be observed when in use.

•   When using glide tips on a walker, short steps should be taken to assure that weight is 

distributed evenly and directly over walker legs. These precautions will prevent 

uncontrollable movement of the walker.



For this procedure, Fefer to FIGURE 1.

When properly installed, the leg 

extension tube edge will rest inside the 

top edge of the new glide tip. If the 

tube edge is visible, the glide tip is not 

installed properly.



There will be an audible “click”.



 WARNING

Ensure the snap button fully protrudes 

through adjustment hole of the rear leg 

extension.

Rear Leg Extension

Glide Tip

Glide Tip NOT Seated 

Properly

Glide Tip Seated Properly