Invacare 9758, Owner'S Operator And Maintenance Manual

15

This Procedure includes the following:

Swingaway Footrest Assembly Installation

Swingaway Footrest Height Adjustment

Heel Loop Replacement

Elevating Legrest Assembly Installation

Adjusting the Elevating Legrest Assembly

SWINGAWAY FOOTREST HEIGHT
ADJUSTMENT (FIGURE 2)

NOTE: Release the footrest locking mechanism and lift
the footrest off of the hinge pins. Lay the assembly on a
flat surface to simplify this procedure.

1. Remove impact guards and/or calf strap, if necessary.

2. Loosen, but do not remove the bolt and locknut that

secure the lower footrest assembly to the upper foot-
rest support.

3. Reposition the lower footrest assembly to the desired

height.

4. Securely tighten the bolt and locknut.

5. Repeat this procedure for the other footrest, if neces-

sary.

6. Replace impact guards and/or calf strap, if necessary.

WARNING

After ANY adjustments, repair or service and
BEFORE use, make sure all attaching hardware
is tightened securely - otherwise injury or dam-
age may result.

SWINGAWAY FOOTREST ASSEMBLY
INSTALLATION (FIGURE 1)

1. Turn the footrest to the side (open footplate is per-

pendicular to wheelchair).

2. Install the hinge plates on the footrest onto the hinge

pins on the wheelchair frame.

3. Push the footrest towards the inside of the wheel-

chair until it locks into place.

NOTE: The footplate will be on the inside of the wheel-
chair when locked in place.

4. Repeat this procedure for the other footrest assembly.

5. To release the footrest, push the footrest release le-

ver inward, rotate footrest outward.

Swingaway

Footrest

Assembly

Hinge

Plate

FIGURE 1 - SWINGAWAY FOOTREST

ASSEMBLY INSTALLATION

Footrest
Release

Lever

Hinge Plate

Hinge Pins

FIGURE 2 - SWINGAWAY FOOTREST HEIGHT

ADJUSTMENT

Upper

Footrest

Support

Bolt and

Locknut

Lower

Footrest

Assembly

HEEL LOOP REPLACEMENT
(FIGURE 3)

NOTE: Heel loops are not available on Invacare MG
wheelchairs.

1. Loosen, but do not remove the bolt and locknut that

secure the lower half of the footrest to the swingaway
footrest assembly.

2. Remove the lower footrest assembly.

3. Remove the phillips screw and locknut that secure

the heel loop to the footrest.

4. Slide heel loop over cane of the footrest assembly.

5. Replace heel loop.

6. Reverse STEPS 1-5 to reassemble.

NOTE: When securing the heel loop to the footrest as-
sembly, tighten the phillips screw and locknut until the
spacer is secure.

F

R

O

N

T

R

I

G
G

I

N

G

S

PROCEDURE 1

FRONT RIGGINGS