Aquatec® Marine
IMPORTANT!
Risk of damage
– The hand control may only be used when the
backrest is properly installed and in the upright
position.
IMPORTANT!
If the battery is not sufficiently charged, the
indicator lamp
B
lights up red when the Down
button
E
is pressed. In this case, the lowering
function of the bath lift is disabled. You can
however still raise the lift.
– Recharge the battery immediately after raising
it.
Raising the bath lift
IMPORTANT!
If the backrest is lowered, it will move into the
upright position first.
1.
Press the Up button
C
on the hand control and keep it
pressed.
The backrest moves into the upright position or the
seat moves upwards.
When moving the backrest into the upright position,
slight crackling noises are possible.
2.
Release the Up button on the hand control.
The bath lift stops in the current position.
Lowering the bath lift
IMPORTANT!
If the seat is already lowered, the backrest lowers
towards the rear.
1.
Press the Down button
E
on the hand control and
keep it pressed.
The seat moves downwards or the backrest lowers
towards the rear.
2.
Release the Down button on the hand control.
The bath lift stops in the current position.
Emergency stop button
IMPORTANT!
Only press the emergency stop button
A
if the
device does not stop immediately when the Up
or Down button is released (e.g. if a button
jams). The bath lift stops moving immediately
and the red light integrated in the hand control
flashes briefly.
If the lifter no longer responds when pressing the Up or
Down buttons after releasing the emergency stop button,
the error has not been corrected. The device is not ready
for use and must be repaired, for example, in case of an
electronic damage.
Contact
Clarke Health Care
,
if
necessary.
16
