SECTION 3—ARMRESTS
1 0
S E C T I O N 3 — A R M R E S T S
W A R N I N G
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Removing/Installing Swing Away Armrests
NOTE: For this procedure, refer to FIGURE 3.1.
Removing Swing Away Armrest
1.
Unlock existing armrest assembly by operate the release lever
.
2. Swing back on the existing armrest to remove from the front arm socket.
3. Push on the rear locking pin to remove it from the rear pivot socket.
4. Repeat STEPS 1
-
3 for opposite side of wheelchair, if necessary.
Installing Swing Away Armrest
1. If necessary, remove existing armrest assembly as describe above
.
2. Install new/existing armrest assembly, first into the rear pivot socket and
into the front arm socket.
3. Lock new/existing armrest assembly by operate the release lever
.
Make sure that the dog point is properly engaged in its housing.
4. Repeat STEPS 1
-
3 for opposite side, if necessary.
FIGURE 3.1
Removing/Installing Swing Away Armrest
Rear pivot
socket
Release lever
Dog point
Front arm
socket
