SECTION 6—FRONT RIGGINGS
31
Installing/Removing Elevating Legrests
NOTE: For this procedure, refer to FIGURE 6.11.
Installing
1. Turn legrest to side (open footplate is perpendicular to wheelchair).
2. Install the legrest hinge plates onto the hinge pins on the wheelchair frame.
3. Rotate legrest toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3
for the opposite
legrest.
5. After the user is seated in wheelchair,
adjust footplate to correct height by
loosening nut and sliding the lower
footrest assembly up or down until
desired height is achieved.
Removing
1. Push the legrest release handle toward
the inside of the wheelchair (facing the
front of the wheelchair).
2. Swing the legrest to the outside of the
wheelchair.
3. Lift up on the legrest and remove from
the wheelchair.
4. Repeat STEPS 1-2
for opposite side of
wheelchair.
FIGURE 6.11
Legrest Release Handle
Bolt/Nut
Calfpad
Legrest
Hinge Plates
Hinge Pins
