Preparing the remote control
A
B
A
C
1.
Remove battery cover
A
from remote control.
2.
Insert batteries
B
. Ensure correct polarity.
3.
Close battery cover of remote control.
4.
Place remote control
D
into its holder
C
.
4.2 Assembling concealed cistern
Installing water flow over angle valve
1.
Connect angle valve and bidet with the PVC Flexible
hose (accessory).
2.
Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit if
necessary.
Installing water flow over flush-mounted housing
1.
Remove the push plate from the flush-mounted housing.
2.
Remove the rear cover plate to obtain a direct
perspective on the connection.
3.
Turn the water tap off.
4.
Remove connecting sleeve
D
and replace by T-piece
E
.
5.
Connect T-piece with PVC Flexible hose
C
.
6.
Connect PVC Flexible hose with tube
A
using nut
B
.
7.
Connect tube
A
with pure bidet.
8.
Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit
if necessary.
9.
Cut-out inner cover plate
F
, mounting plate
G
and
push plate
H
according to the figure above taking into
account the indicated dimensions [mm].
10. Re-attach the inner cover plate and the mounting plate
inside the flush-mounted housing.
11. Close flush-mounted housing with the push plate.
Following parts are needed for the assembly of the
flush-mounted water flow but are not included in
the scope of delivery:
•
Tube
A
•
Nut
B
Available at your specialised dealer.
1590625-D
15
Summary of Contents for Aquatec Pure Bidet
