Invacare AT5044, Assembly, Installation And Operating Instructions

Part No 1130220

2

Elevating Legrests

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 1.

Installing

1. Place elevating legrest on the outside of the wheelchair and insert mounting pin into 

the mounting tube.

2. Rotate elevating legrest toward the inside of the wheelchair until it locks in place.

NOTE: The calfpad of the legrest will be on the 
inside of the wheelchair when locked in place.

3. Repeat STEPS 1-3 for the other 

elevating legrest assembly.

Removing

1. Push the legrest release handle inward 

while rotating the elevating legrest 
outward.

2. Lift the legrest assembly out of the 

mounting tube of the wheelchair frame.

3. Repeat STEPS 1-2 for opposite side, if 

necessary.

FIGURE 1   

Installing/Removing Elevating 

Legrests

Raising/Lowering the Elevating Legrest

NOTE: For this procedure, refer to 
FIGURE 2.

1. Perform one of the following:

• Raising: Lift legrest assembly up to 

desired height.

• Lowering: Lift elevating legrest 

assembly up with one (1) hand. 
While supporting the eleveting 
legrest assembly (and user’s leg), 
pull release lever up with other 
hand and lower legrest assembly to 
desired height.

FIGURE 2   

Raising/Lowering the Elevating 

Legrest

Release Handle

NOTE: The mounting tube will be part of the 
seat frame or wheelchair front frame 
depending on wheelchair model.

 Mounting Pin

 Mounting 

Tube

Elevating 

Legrest

Inside of 

Wheelchair

Release Lever

Elevating Legrest 

Assembly