1.
Loosen and remove handscrew
A
.
2.
Curved side of adapter must face away from
backrest frame.
Install adapter:
•
Backrest plates: Insert adapter
B
into slot of
backrest plate
C
.
•
Tension-adjustable backrest: Insert upper adapter
B
and lower adapter
E
into slot until it clicks.
3.
Insert Elan headrest tube
D
into adapter.
4.
Attach and tighten handscrew
A
.
Fig. 5-4
Fig. 5-5
5.6 Replacing posture belts
5.6.1 Installation on backrest mounting bracket
(backrest frame)
Tools:
•
13 mm socket spanner
•
5 mm Allen key
•
Posture belts are attached via drill hole (1) on the
top right.
5.6.2 Installation on backrest mounting bracket
(telescopic seat frame)
Tools:
•
5 mm Allen key
1.
Loosen screw
A
with a 5 mm Allen key.
2.
Remove screw
A
, corresponding washer
B
, seat belt,
stopper
C
and belt winder
D
from backrest mounting
bracket
E
.
3.
Replace posture belt.
4.
Install parts in reverse order.
5.6.3 Installation on seat frame profile
(telescopic seat frame)
Tools:
•
5 mm Allen key
1.
Loosen screw
A
with a 5 mm Allen key.
2.
Remove screw
A
, washers
B
, seat belt, stopper
C
,
sliding bushing
D
and T-nut
E
from seat frame profile
F
.
3.
Replace posture belt.
4.
Install parts in reverse order.
5.6.4 Replacing H-belt (telescopic seat frame)
Note:
•
13 mm socket wrench
•
5 mm Allen key
1604311-G
23
