Tools:
•
8 mm Allen key
1.
If necessary, disconnect joystick.
2.
Loosen screw
A
.
3.
Pull the armrest
B
out of mounting bracket.
4.
If necessary, replace the armrest including the
mounting bracket.
5.
Install parts in reverse order.
5.7.3 Replacing skirt guard on inrigged armrest
with smaller skirt guard
Tools:
•
4 mm Allen key
Use the smaller skirt guard for seat depth (41 cm)
and above.
1.
Loosen and remove two screws (3).
2.
Take off skirt guard.
3.
Replace skirt guard with smaller skirt guard.
4.
Retighten two screws.
5.7.4 Adjusting/fixing angle of lateral supports
Tools:
•
6 mm Allen key
1.
Remove cover.
2.
Loosen screw
A
that allows angle adjustment of
lateral supports.
3.
Adjust supports to desired angle.
4.
Replace cover.
5.
Re-tighen screws.
5.8 Replacing remotes/remote holders
5.8.1 Replacing Nucleus Midline Holder
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod,
can lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
– Check end cap for tight fitting.
•
4 mm Allen key
•
3/16 inch Allen key
Fig. 5-6
The bracket can be mounted either on the left- or
right-hand side of the mobility device via a slot
A
under the armrest bracket.
Removing Holder
1.
Loosen screw
B
.
2.
Remove adapter
C
including nucleus
D
from slot
A
under armrest bracket.
3.
Loosen screws
E
.
4.
Remove adapter.
5.
Replace nucleus.
1604311-G
25
