Assembly
Attaching the cables
A
B
1.
Attach the cable for the battery charger
A
and for the battery
B
to the frame with two separate cable ties.
Charging the battery
Damage to the battery
–
The battery must be loaded 24 hours before using the
system the first time.
–
Unplug the mains cable after loading before the
wheelchair is moved.
The battery charger has different charging cables in order to
adapt to different local electrical standards.
When the battery level is low (20 V), the hand control beeps
when it is used.
B
A
A
A
1.
Connect the charger cable supplied with the chair into a wall
socket.
2.
Insert the charger cable
A
into the connector
B
which is on the
side of the wheelchair.
3.
Unplug the cable when the battery is fully charged.
A
B
C
D
A
Green light — ON — Hand control is activated
B
•
Green light — ON — Battery level is above 20%
•
Green light blinking — ON — Battery is charging (fixed
light when the battery is fully loaded)
C
•
Yellow light — ON — Battery level is low, below 20%
•
Yellow light — OFF — Battery is fully loaded
D
Green light — ON — Battery cable is connected (lights up
about 5 seconds after connecting the cable)
2.14.2
Mounting the pistons
WARNING!
Risk of injury
The wheelchair may collapse
–
Check that the locking washers are securely locked.
–
If the safety pin is used, make sure that the lock shackle
/ loop is securely locked.
WARNING!
Safety risk
The wheelchair may collapse
–
Remember to always reinsert and fasten the safety pin
when it has been removed.
–
Check that the lock shackle / loop is securely locked.
Piston for backrest recline
C
D
B
A
E
E
Azalea Max
C
D
B
A
E
E
Azalea
1.
Place the attachment to the piston for the backrest recline
C
in
the attachment
A
on the frame.
2.
Fixate the attachment with the safety pin
B
.
3.
Place the front part of the piston in the front attachment
D
on
the frame.
4.
Fixate the piston with the screw, sleeves and nut
E
.
The screw, sleeves and nut also fixates the battery to the
front attachment
D
. See section “Mounting the battery”
for more instruction about how to mount the battery.
5.
Tighten the screw.
6 mm allen key / 13 mm fixed spanner
1580313-B
13
