Azalea®
Piston for seat tilt
A
B
C
F
E
D
D
1.
Place the upper part of the piston for the tilt
A
in the attachment
C
on the frame.
2.
Fixate the piston with the safety pin, sleeve and locking washer
D
.
3.
Place the lower part of the piston for the tilt
A
in the lower
attachment
B
on the frame.
4.
Fixate the lower part with the sleeves
F
, safety pin and the
locking washer
E
.
5.
Tighten the screws.
Nippers
Attach the cables
G
H
I
1.
Attach the cable for the seat tilt
G
to the frame with a cable tie.
2.
Attach the cable for the backrest recline to the piston with a
cable tie.
3.
Attach both cables to the control box
I
with a cable tie.
2.14.3
Cable lock — piston
Cable lock removal
A
1.
Loosen the cable lock
A
.
Use a screwdriver to loosen the cable lock.
2.
Remove the cable lock from the piston.
CAUTION!
Damage to the product
–
When a cable lock is removed, it must be replaced
by a new one.
Mount the cable lock
C
B
1.
Mont the cable lock
A
by pushing it into place on the piston
B
.
CAUTION!
Risk of damage to the product
–
The cable lock must be mounted when washing the
wheelchair.
2.14.4
Mounting the control box
E
B
G
B
F
1.
Mount the attachment
B
with the attached control box on the
chassis.
2.
Fixate the attachment
B
with the screws and washers
E
, sleeves
F
and nuts
G
.
3.
Tighten the screws.
3 mm allen key / 8 mm spanner
14
1580313-B
