Settings and Adjustments
3
Settings and Adjustments
3.1
Backrest plate
3.1.1
Height adjustment backrest plate
Risk of damage
Poor functionality on the backrest.
–
Any adjustments made to the backrest should be
evaluated by trained personnel.
A
You can easily adjust the backrest plate (+130 mm).
1.
Loosen the four screws
A
.
2.
Set the backrest plate to the required height.
3.
Re-tighten the screws.
Tools: 5 mm Allen Key.
The height of the “Laguna” backrest plate is adjusted in the
same way. Maximum height adjustment is 110 mm.
The “Laguna” backrest cushion is the only available cushion
choice for the “Laguna” backrest plate.
Any adjustments made to the backrest should be evaluated
by trained personnel.
CAUTION!
Risk of pinching
When adjusting the height these is a risk of pinching your
finger.
–
Be careful when adjusting the height.
A
B
A
Upper screws for additional height adjustment
B
Lower screws for additional height adjustment
For additional height adjustment (50 mm):
1.
Loosen screws.
2.
Set the required height.
3.
Re-tighten the screws.
Tools: 5 mm Allen Key
3.1.2
Width adjustment backrest plate
WARNING!
Risk of breakage
The backrest might brake if adjusted too wide.
–
If you have seat width 490 mm (max seat width)
the backrest should NOT be adjusted to the widest
possibility (+100 mm).
A
B
Tools: 5 mm Allen Key
For width adjustment:
1.
Remove the upper screw
A
, and loosen the lower screws
B
.
2.
Adjust to the required width (+25 or 50 mm on each side).
3.
Re-insert the upper screw and tighten.
4.
Tighten the lower screws
The “Laguna” backrest plate is not possible to adjust in
width, only in height.
3.2
Special adaptation of Flex 3 backrest
WARNING!
Safety risk
–
All changes to the back are seen as a special adaptation
of the product. That means that the rules for special
adaptation are in force. All adaptations must be
documented and a risk asessment must be carried out.
The adaptor is responsible for the adaptions.
1580313-B
17