Azalea®
WARNING!
Risk of damage
Incorrect mounting of the gas spring
–
This procedure must only be performed by a service
technician.
Other Azalea models can use either gas spring position (
C
or
D
).
When using electric tilt though, only gas spring position
C
can be used.
WARNING!
Risk of pinching
–
The wheelchair should be tipped over sideways before
the gas spring is loosened from the chassi attachment.
Otherwise there is a risk of pinching.
Angles obtained:
Gas piston position
C
with 16 inch rear wheels:
-1 — +23 degrees
Gas piston position
C
with 24 inch rear wheels:
-1 — +23 degrees
Gas piston position
D
with 16 inch rear wheels:
+1 — +24 degrees
Gas piston position
D
with 24 inch rear wheels:
+1 — +24 degrees
3.6
Re-adjustment — armrest / legrest
Risk of poor adjustment
–
There must not be any pressure on the armrest /
legrest while adjusting the screw.
A
After a period of use, the screws
A
may need to be
re-tightened (12Nm).
3.7
Positioning the headrest/neckrest to the
front
This additional depth adjustment will move the headrest
another 7 cm forward.
A
C
D
E
A
C
D
You can also adjust the angle and depth by turning the
attachment for the headrest / neckrest.
1.
Loosen the handwheel
A
.
2.
Remove the headrest / neckrest.
3.
Loosen the handle
D
.
4.
Remove the screw and the handle.
5.
Rotate the headrest / neckrest attachment pole including the
attachment
E
.
6.
Return the headrest / neckrest to the attachment.
Note that the screw to the headrest / neckrest attachment
C
and the handle
D
must be mounted on the opposite side
due to the groves in the screw hole.
7.
Return the headrest / neckrest to the attachment on the backrest.
8.
Re-tighten the handle
D
.
3.8
Width adjustment
1.
4x
A
Loosen the 4 screws
A
.
2.
B
Adjust the attachment bars
B
in order to fit the table to the
desired width. Re-tighten the screws.
3.
C
Fit the table to fit the width of the chair
C
.
22
1580313-B
