Settings and Adjustments
3.9
Adjusting the width of the legrest
A
1.
Loosen the screws
A
.
Tools: 5 mm allen key
2.
Adjust the legrests to the desired width.
3.
Re-tighten the screws.
3.10
Adjusting the user/foot operated tilt
1.
A
Adjust the tilt resistance with the adjustment nut
A
on the wire.
2.
B
C
Fixate the wire in the holder with the fixation nut
B
. When the
desired tilt resistance is achieved, fixate the position with the
fixation nut
C
.
3.11
Azalea Base — tilt and recline
3.11.1
Backrest angle — rigging screw
A
B
1.
To adjust the angle of the backrest, first loosen nuts
A
on the
rigging screw.
Tools: 17 mm fixed spanner.
2.
Turn the metal tube
B
to set the desired angle for the back.
3.
Re-tighten the nuts.
CAUTION!
Risk of discomfort for the user
The low pivot point causes shearing when the back is
reclined, this might result in discomfort for the user.
–
Make sure that the user is well positioned after each
adjustment.
3.11.2
Backrest tilt — carer operated
•
The Azalea Base can also be equipped with gas pistons for carer
operated controls.
•
You can adjust the angle of the backrest forwards or backwards
and tilt the whole seat unit including the backrest.
•
These two functions can either be controlled manually or
electrically.
A
CAUTION!
Risk of damage
The gas piston attachment
A
will scratch the surface
on the chassis cross tube. This might eventually lead to
corrosion.
–
The seat unit needs to be tilted slightly before the back
is dismounted/folded.
1580313-B
23
