Assembly
2
Assembly
2.1
Placing the wires
2.1.1
Wires with backrest plate
A
B
1.
Thread the wires on the outside of the backrest tubes
B
.
2.
Place the wires in the holders/clips
A
in order to hold them in
place.
Fold the slack of the wires under the seat to get them
out of the way.
2.1.2
Wires with tension adjustable backrest
A
B
C
C
D
E
1.
Place the wires
A
and
B
as shown on the picture above.
Risk of damage to the wires
–
It is important that the cable for the assistant brake
A
is placed on the inside of the backrest tubes.
2.
Place the wire for the backrest/seat recline
B
outside of the
backrest tubes.
3.
Place both of the wires on the inside of the backrest attachment
C
.
4.
Attach the wires to the backrest tubes
E
with the straps
D
.
Fold the slack of the wires under the seat to get them
out of the way.
CAUTION!
Risk of reduced brake effect
–
The wires must not be crossed on the backrest!
2.2
Mounting the angle adjustable push bar
1.
A
A
B
Loosen and remove the screws
A
and the brake handles
B
.
2.
D
C
Loosen the handwheels
C
and remove the push handles
D
.
1580313-B
5
