Service
Component
Check
Remedy
Notes
Check status display
(flashing)
Evaluate flash code
Check fixing
Tighten or replace
fixing
Check cable,
connecting plug
Replace cable,
connecting plug
Check drive lever
function
Replace drive lever
Drive controls
Check power supply
Replace cable,
connecting plug
or console
Drive program
Check drive
program version.
New version
available?
Update software
Check cable and
connecting plug
Adjust or replace
sensor on curve
control device
Curve control in bends
Check function
Screws
Check screws for
tight fit
Tighten screws if
necessary
4.5 Controls
4.5.1 Replacing operating console
CAUTION!
Risk of burns if power cable is shorted
– Turn off the power completely before removing
any power supply components of mobility
device. Therefore take out batteries.
– Avoid bridging of contacts during measurements
on live electrical components.
Risk of damage to operating console/circuit
board by instant high current/voltage
– Unplug battery cable before removing/installing
operating console.
– Make sure all pins are correctly connected.
The plugs on the operating console cannot be
wrongly connected because all plugs have a different
size and only fit in one socket.
•
Phillips screwdriver
Setting battery gauge is mandatory when retrofitting
operating console.
Setting wheel diameter is mandatory when
retrofitting operating console.
1.
Remove seat.
2.
Remove shroud.
3.
Disconnect battery cable
A
.
4.
Remove top shroud
A
from steering column
B
.
1603798-B
11
