Comet
1.
Press key to increase value.
2.
Press key to decrease value.
3.
Press key to save and leave setup settings.
Entering setup (LED Display)
This chapter applies for mobility devices with LED
display.
1.
Turn key to switch mobility device off.
2.
Press and hold keys.
3.
Turn key to switch mobility device on.
Mobility device enters setup mode after two seconds.
LED 2 and LED 8 will flash.
4.
Release keys to enter setup settings.
Setting battery gauge
This chapter applies for mobility devices with LED
display.
Setting battery gauge is mandatory when retrofitting
operating console.
Adjust the parameter in battery gauge to suit different types
and sizes of batteries.
AGM battery
Gel battery
(1) big size
batteries (>
50 A)
(2) small
size batteries
(< 50 A,
default)
(3) small size
batteries (<
50 A)
(4) big size
batteries (>
50 A)
1.
Press key to change settings.
2.
Save settings by waiting for 10 seconds or pressing any
other keys except keys above.
4.6 Shrouds
4.6.1 Removing shroud
CAUTION!
Risk of damage to shroud
– Do not pull shroud straight up to remove.
– Follow instructions below.
1.
Place one hand at the front, the other at the rear of
the shroud
A
.
2.
Lift shroud up from front.
3.
Place hands on left and right side of shroud.
4.
Twist and lift to remove shroud completely.
4.6.2 Replacing front shroud
•
10 mm socket wrench
•
Phillips screwdriver
18
1603798-B
