Comet
6.
Remove screws (3) on indicator glass.
7.
Remove indicator glass.
8.
Loosen screws (4) on orange-colored cap (5) and remove
cap.
9.
Replace lightbulb.
10. Install parts in reverse order.
11. Test functions.
4.7.3 Replacing center brake light
CAUTION!
Risk of burns if power cable is shorted
– Turn off the power completely before removing
any power supply components of the mobility
device. Therefore take out the batteries.
– Avoid bridging of contacts during measurements
on live electrical components.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
•
Phillips screwdriver
1.
Remove seat.
2.
Remove shroud.
3.
Disconnect battery cable
A
.
4.
Disconnect plug (4).
5.
Remove bolts
A
on rear shroud.
6.
Lift rear shroud upwards.
7.
Remove screws (1) on brake light.
8.
Replace brake light.
9.
Install parts in reverse order.
10. Test functions (trial run).
4.7.4 Replacing rear lights/direction indicators
CAUTION!
Risk of burns if power cable is shorted
– Turn off the power completely before removing
any power supply components of the mobility
device. Therefore take out the batteries.
– Avoid bridging of contacts during measurements
on live electrical components.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
20
1603798-B
