Comet
Replacing steering column
1.
Remove drive lever screws
C
.
2.
Remove drive lever
B
.
3.
Loosen and remove screws
A
on operating console.
4.
Remove operating console. See
4.5.1 Replacing
operating console, page 11
.
5.
Remove screws
A
on rear steering column shroud.
6.
Remove steering column shroud.
7.
Loosen screws on front basket holder.
8.
Remove basket holder.
9.
Remove spacer bushes.
10. Disconnect cables from wiring harness.
11.
Remove screws
A
on front steering column shroud.
12. Remove front steering column shroud.
13. Loosen brake cable. See
4.9.1 Replacing hand brakes,
page 26
.
14.
Loosen and remove screw at clamp (1).
15. Loosen and remove fixing bolt for steering column.
16. Pull steering column out upwards.
17. Install parts in reverse order.
Tighten screw (1) to 13 Nm.
18. Apply brake, tighten axle bolts at same time.
19. Test all functions (trial run).
4.8.5 Replacing front wheel suspension 4–wheel
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
•
10 mm wrench
•
13 mm wrench
•
17 mm wrench
•
19 mm wrench
•
32 mm wrench
•
Phillips screwdriver
•
Supporting wooden block
24
1603798-B
