Troubleshooting
6
Troubleshooting
6.1
Limitation areas — Troubleshooting
When adjusting the centre of gravity, some settings can cause
limitations in some positions. This can happen for example when
adjusting the:
•
Seat tilt
•
Seat depth
•
Backrest recline
The following sections will give some examples of the possible
limitations, but also suggestions about solutions.
6.1.1
Seat tilt
A
B
A
C
When the seat is tilted, the backrest attachment
A
can collide with
the rear wheel axle
B
or the rear wheel attachment
C
.
Possible solutions:
•
Move the rear wheel attachment
C
further backwards.
•
Turn the rear wheel attachment
C
in order to have the rear
wheel positioned further backwards.
•
Choose the low mounting position for the rear wheel attachment
C
.
This will increase the seat height, to compensate, use
a longer front wheel fork.
A
•
Use the tilt reduction bushing
A
in order to avoid the limitation.
The seat tilt will have slightly reduced angling
possibilities.
6.1.2
Seat depth
D
B
C
D
When the seat is tilted, and the seat plate
D
is adjusted in depth,
the seat plate
D
can collide with the rear wheel axle
B
or the rear
wheel attachment
C
.
Possible solutions:
•
Move the seat plate
D
forwards to increase the seat depth.
•
Move the rear wheel attachment
C
further backwards.
•
Turn the rear wheel attachment
C
in order to have the rear
wheel positioned further backwards.
•
Choose the low mounting position for the rear wheel attachment
C
.
This will increase the seat height, to compensate, use
a longer front wheel fork.
A
•
Use the tilt reduction bushing
A
in order to avoid the limitation.
The seat tilt will have slightly reduced angling
possibilities.
6.1.3
Backrest recline
E
B
C
E
When the backrest is reclined, the backrest tube
E
can collide with
the rear wheel axle
B
or the rear wheel attachment
C
.
Possible solutions:
•
Move the rear wheel attachment
C
further backwards.
•
Turn the rear wheel attachment
C
in order to have the rear
wheel positioned further backwards.
•
Choose the low mounting position for the rear wheel attachment
C
.
This will increase the seat height, additional measures
may have to be taken into consideration, for example to
use a longer front wheel fork.
A
•
Use the tilt reduction and / or the backrest recline reduction
bushing
A
in order to avoid the limitation.
The seat tilt and / or the backrest recline will have
slightly reduced angling possibilities.
See section: “Tilt and / or backrest recline reduction” for
information about the tilt reduction.
1572308-B
31
