65
10.1
Disassembly & Folding
To enable your chair to be carried in the boot of most cars, pleas follow these instructions:
1.
Follow the steps in 7.1 to remove the backrest.
2.
Follow the steps in section 7.7 to remove the armrests. Ensure the controller is unplugged before carrying
out this operation.
3.
Follow the steps in section 7.11 to remove the seat board.
4.
Follow the steps in section 8.1 to remove the batteries.
5.
Follow the steps in section 7.12 to remove the kerb climber.
6.
Follow the steps in section 7.13 to remove the leg rests.
7.
To fold the chair, take hold of the seat tube and lift. Your powerchair is now ready to be loaded safely in a
suitable vehicle. Reversing the procedure will make your chair ready for use at your destination.
If your power chair features a slung seat upholstery assembly, follow the above steps ignoring step 3.
NOTE:
If stored or transported when folded ensure the motor cables are not trapped, or have weight pressing on
them, by inserting a pad or similar item between the motors.
