SECTION 4—INSPECTION AND COMPRESSOR INTERFACE
17
11. After the cylinder is full, press the compressor power
switch to the Off (O) position (FIGURE 4.6).
12. Grasp the cylinder assembly (FIGURE 4.6).
13. With the other hand, grasp the outer ring (sleeve) of the
connector fillport and push DOWN (FIGURE 4.6).
14. Lift up on the cylinder assembly to remove from the
connector fillport (FIGURE 4.6).
FIGURE 4.6
Disconnecting the Cylinder from the Compressor
15. When the cylinder fillport is disconnected from the
connector fillport, release the outer ring (sleeve) of the
connector fillport (FIGURE 4.6).
16. Remove the cylinder from the compressor cradle (FIGURE
Cylinder
Assembly
Compressor
Cylinder
Fillport
Connector
Fillport
Outer Ring
(Sleeve)
PUSH DOWN
Power
Switch