Assembly
4.3 Assembling the Manual/Hydraulic Pump to
the Boom
CAUTION!
–
DO NOT overtighten the mounting hardware. This
will damage the mounting bracket.
1.
Remove the quick release pin
A
from the mast mounting bracket
B
(Detail A).
2.
Lift the hook
C
securing the hanger bar
D
to the mast.
The hanger bar is not shown in the hook in Detail A.
3.
Remove the caps
E
, bolt
F
, washers
G
and nut
H
from the
mounting bracket
I
on the boom
J
(Detail B).
The bottom of the hydraulic pump assembly
K
will
already be assembled to the mast mounting bracket
(Detail C).
4.
Lift-up on the boom and place it on your left shoulder.
5.
Let the hydraulic pump rest on the right-side of your chest and
rotate the shaft extension
L
of the hydraulic pump assembly
until it lines-up with the mounting bracket holes on the boom.
6.
Align the holes of the mounting bracket with those of the shaft
extension
7.
Install the bolt, washers, nut and caps.
Be sure that the bolt is completely through the holes of
the boom mounting bracket and the manual/hydraulic
pump assembly. The boom assembly will pivot easily if the
mounting hardware is aligned properly when the boom is
secured to the mast.
1171892-A
15
Summary of Contents for I-Lift ILIFTEE
