Leg rests assembly
2
3
4
1
5
Leg rests are supplied in pairs one left one right.
To install;
From the side take the leg rest and insert onto the locking pins (1) located at the
front of the chair, swing the leg rest to the front, the leg rest will lock into position,
the footplate should be on the inside of the chair.
To remove;
Depress (2) and swing the leg rest to the rear, once to the side, lift and remove,
the leg rest may be left in place.
To adjust footplate height;
Figure (3) and (5) are connected by a hexagonal nut and bolt, leave leg rest on the
chair, take a spanner and loosen the nut, it is not necessary to remove, once loosen
take hold of lower leg rest (3) and move up or down to the desired height, tighten
nut.
Note; it is suggested that the upper legs are horizontal to the seat rail; if in doubt
contact your healthcare professional.
Warning;
Do not stand on the footplates, as the chair may tip.
7
