5.0 ETAC Recline Adjustments
(for greater seat depth)
1
Image
(1)
illustrates a back installed at the maximum
depth, and the ETAC back canes in their upright (non-
reclined) position.
(
Note:
As shown in this configuration,
access to the adjustment hardware can be difficult)
2
To increase the recline angle of the ETAC back canes,
loosen the 13mm nut at the bottom of each back cane
(2)
. Adjust the recline angle via the slotted channel at
the bottom of each back canes
(3)
.
(
Note:
Ensure that
both back canes are adjusted equally)
. Following the
recline adjustments, the mounting plates may also require
adjustment to compensate for revised back cane angle.
Adjusting the Recline Angle of the Back Canes
NOTE
: For users that require maximum depth for their back cushion, it may be
necessary to adjust the recline angle of the ETAC back canes in order to maximize the
seat depth, and provide better access to the adjustment hardware.
3
Image
(4)
shows the ETAC back canes in the re-
clined position with the ETAC mounting hardware
re-adjusted to compensate for the new recline
angle. This reclined back cane configuration
creates more available space for depth adjustment,
and improves access to the adjustment screws/
hardware.
Fully recline
back cane
Recline Angle
Adjustment
13 mm
Nut
Upright
back cane
position
2
1
3
4
TRD0305- ETAC Mounting Hardware Installation Instructions- Europe, Rev 1.0_Layout 1 29/02/2012 12:43 PM Page 7
- 7 -
