Service
Removing H-belt
1.
Remove protective cap (2).
2.
Loosen and remove screw (6), associated washers (5) and nuts
(4) (in front of the/behind the gripper clamp (3)) with a 5 mm
Allen key and a 13 mm socket wrench.
3.
Remove protective cap (9).
4.
Loosen and remove screw (8), associated washers (7) and nuts
in the lower part of the harness belt (1) with a 5 mm Allen key
and a 13 mm socket wrench.
Another nut is installed between washers as a spacer, so
that the belt bracket can move freely.
5.
Replace harness belt (1).
Installing H-belt
1.
Install parts in reverse order.
4.5
Replacing armrests and upper body
support options
For armrests and upper body support options, see 4.2.4 Armrest
styles, page 8 and 4.2.5 Upper body support options, page 9 .
4.5.1
Removing/ Installing armrest
This chapter applies for armrests on the telescopic seat
frame.
Tools:
•
8 mm Allen key
1.
If necessary, disconnect joystick.
2.
Loosen Allen screw (1) with an 8 mm Allen key.
3.
Pull armrest (2) out of mounting bracket.
4.
If necessary, replace armrest including mounting bracket.
5.
Install parts in reverse order.
4.5.2
Removing/Installing armrest
This chapter applies for armrests on the one piece seat plate.
Tools:
•
8 mm Allen key
1.
If necessary, disconnect joystick.
2.
Loosen screw
A
.
3.
Pull the armrest
B
out of mounting bracket.
4.
If necessary, replace the armrest including the mounting bracket.
5.
Install parts in reverse order.
4.5.3
Replacing skirt guard on inrigged armrest with
smaller skirt guard
Tools:
•
4 mm Allen key
1604311-A
13
Summary of Contents for Modulite Bora XTR Series
Page 26: ...Notes...
Page 27: ...Notes...
