Invacare® Modulite
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod, can
lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
– Check end cap for tight fitting.
4.4.1 Adjusting Depth of Midline Holder
1.
Loosen lever
A
.
2.
Shift midline holder to desired position.
3.
Tighten lever.
4.4.2 Adjusting Height of Nucleus Midline Holder
You can adjust the height of the nucleus midline holder in
two ways:
•
Adjust it together with the armrest height. Refer to
corresponding armrest chapters.
•
Adjust the height of the nucleus midline holder only.
Refer to section below.
•
3/16 inch Allen key
Fig. 4-6
1.
Loosen screw
A
.
2.
Adjust nucleus to desired height.
3.
Tighten screw.
4.4.3 Adjusting Joystick/Display Position on Nucleus
Midline Holder
DLX-REM110, DLX-REM2XX, DLX-REM400
•
4 mm Allen key
•
8 mm wrench
Tilting Remote
Fig. 4-7 Example of DLX-REM400 adjustment. DLX-REM110,
DLX-REM211 and DLX-REM216 are adjusted the same way.
1.
Loosen screws
A
.
2.
Position remote on nucleus.
3.
Tighten screws.
Rotating Remote
16
1656515-B
