Invacare® Modulite
1.
Fold the foot plates up in order to access the adjusting
screws (1).
2.
Set the adjusting screws using the Allen key.
3.
Fold the foot plate down again.
4.24.3 Setting Angle of Footboard
•
5/32 inch Allen key
Fig. 4-51
1.
Fold the foot platform up in order to access the
adjusting screw
A
.
2.
Set the adjusting screw using the Allen key.
3.
Fold the foot platform down again.
4.24.4 Setting Height and Width of Calf Pad
Risk of damage to the mobility device
– After changing the configuration of the calf
pads make sure that the calf pads contact
neither the casters nor the seat plate when
adjusting the legrest angle.
Calf pads may be adjusted independently on their respective
mounting bracket using the mounting screws at the rear of
the calf pads. Calf pads may be adjusted (for depth, height
& angle) to achieve a variety of different configurations. The
independent pad adjustments provide optimal positioning
and comfort for end users - sample configurations are
illustrated below.
Calf Pad Adjustment — Sample Configurations
Centered
Extended
Position
(maxi-
mum)
Lowered
Offset
Raised
Offset
Angled
•
4 mm Allen key
1.
Fold the calf pad forward in order to access the bolts.
2.
Loosen the bolts and remove them if necessary.
3.
Adjust the calf pad to the required height and width.
4.
Retighten the bolts.
5.
Fold the calf pad back.
44
1656515-B
