SECTION 6—VAN SEAT
Pronto® Series
56
Part No. 1125075
Adjusting Seat Position on Seat Base
WARNING
Refer to the table in FIGURE 6.8 for proper seat post mounting positions. For users
over 220 lbs - seat MUST be in the 1-inch back position (FIGURE 6.8) when using
seat post mounting holes 3, 4 and 5 (FIGURE 6.6). Refer to Adjusting the Seat
Height on page 53.
NOTE: For this procedure, refer to FIGURE 6.8 on page 57.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.
2. Remove the four mounting screws and washers securing the seat pivot to the seat base
(FIGURE 6.8).
3. Separate the seat pivot from the seat base.
4. Refer to FIGURE 6.8 to determine the correct mounting holes to achieve the desired
seat position.
5. Align the mounting holes on the seat pivot (determined in STEP 4) with the mounting
holes on the seat base.
6. Using the four mounting screws and washers, secure the seat base to the seat
assembly. Securely tighten.
7. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 50.
