Invacare rea Bellis, Assembly Instructions Manual

5

REA BELLIS

A

B

C

E

D

F

G

H

I

J

K

A

B

C

D

E

F

H

I

J

K

G

C

2.

1.

3.

4.

3.

  Press down the foot brake tube with your foot 

to apply the brake.

4.

  Push the foot brake tube upwards with your foot 

to release the brake.

1.

  Fit screw (G) into mounting plate (F) and nut 

(E). Then fi t link bushing (K) into the hole on the 
inside of mounting plate (F). Fit link washer (I) 
into the hole on the outer side of mounting plate 
(F). Tighten using screw (H) through the bushings 
to brake tube (A). 

Fit nut (E) in the required position on transport 
wheel plate (B). Sleeve (J) is to be fi tted into the 
hole on the mounting plate and everything is to be 
securely locked into place on the transport wheel 
plate using nut (D) and washer (E).

2.

  Fit nut (B) onto eye bolt (D). Fit eye bolt (D) 

to the brake arm on the transport wheel using 
screw (E). Fit washer (C) between eye bolt (D) 
and the brake arm and tighten nut (A). Then fi t 
fork link (G) onto eye bolt (D). Press axle (L) 
securely onto the transport wheel through the 
mounting plate. Lock into place using washer 
(H) and screw (I). Tighten with nut (A). Lock the 
wheel into position with washer (J) and nut (K). 
Turn the fork link upwards and lock it into place 
onto the brake tube with lock clip (F). Follow the 
same procedure for the other side.

It is easiest to adjust the brake if you turn the 
wheelchair upside down.

1.   Loosen nut (B).
2.   Loosen lock clip (F) and pull it out.
3.   Turn fork link (G) outwards to adjust the 

braking effect.

4.   Lock fork link (G) into place with lock clip (F) 

and tighten nut (B).

5.   Adjust fork link (G) by an equal amount on 

both sides.

6.   Test to check that the braking effect is even, by 

spinning both wheels and braking. Both

wheels should now be braked simultaneously.

7.  Turn over the chair so that the wheels are on 

the ground, and then test the brakes.

8.   If additional adjustment is necessary, repeat 

steps 1-5. 

Tools:  4 mm Allen Key
 

5 mm Allen Key

7mm fixed spanner

10 mm fixed spanner

19 mm fixed spanner

19 mm box spanner

Foot brake (only for

16” wheels, seat height 47 cm)