Rea® Clematis®
3 Setup
3.1 Delivery check
Any transport damage must be reported immediately to
the transport company. Remember to keep the packaging
until the transport company has checked the goods and a
settlement has been reached.
3.2 Assembly
When you receive your wheelchair, you must fit the backrest
into place and fit the neckrest, armrests and legrests on the
chair. The assembly is simple and does not require any tools.
3.2.1 Unfolding the backrest
1.
Unfold the backrest into an upright position.
2.
B
D
D
B
When fastening the safety pin
B
, tilt the backrest slightly
forward while supporting the gas piston manually.
3.
When the holes are aligned, the safety pin
B
can be
attached.
4.
Secure the piston with the safety pin
B
.
5.
Lock the pin using the lock shackle / loop
C
.
6.
Secure the backrest cushion using the Velcro strips.
WARNING!
Safety risk
The wheelchair may collapse
– Remember to always reinsert and fasten the
safety pin when it has been removed.
– Check that the lock shackle / loop is securely
locked.
3.2.2 Fitting the armrests
A
B
1.
Fit the armrest
A
in the armrest attachment
B
.
Make sure that the armrest is securely locked
into position.
CAUTION!
Risk of pinching fingers
– Be careful not to pinch your fingers between
the frame and the side guard when mounting
the armrest.
3.2.3 Fitting the rear wheels
B
A
C
1.
Press and hold in the quick-release button
B
in the
center of the hub.
2.
Put the rear wheel and the rear wheel axle
C
in the
rear wheel attachment
A
and release the button
B
.
3.
Pull the wheels outwards to check that the wheel is
securely locked in its position.
WARNING!
Risk of injury
– Check that the rear wheel is securely locked
in its position! It should not be possible to
remove the wheels when the quick-release
button is inactivated.
8
1439960-D
