SAFETY SUMMARY (CONTINUED)
INSTALLATION WARNINGS
SPRINT (65400) and SPARTAN (65420)
MODELS - The rollator height can ONLY be
adjusted where the push handle is textured
(FIGURE 4).
After installation and BEFORE use, ensure
that ALL attaching hardware is securely
tightened.
REPLACING SPRINT CANES AND
BRAKES (FIGURE 1)
1. Remove the EXISTING brake wire. Perform the fol-
lowing:
A. Loosen, but DO NOT remove the phillips screw
securing the brake wire to the brake wire clamp.
B. Remove the brake wire clamp and set aside.
C. Pull wire through the hole in the brake.
D. Remove the spring and set aside.
E. Pull wire through cable adjuster unit. If necessary,
loosen the cable adjuster unit locknut.
2. Pull brake cable UP to remove from side frame. If
necessary, cut ty-wrap.
3. Perform one (1) of the following:
INSTALLING CANE KIT - Remove EXISTING push
handle.
A. Rotate adjustment lever counterclockwise to
loosen. DO NOT remove.
B. Pull UP on the push handle to remove.
INSTALLING BRAKE KIT (BEFORE 3/7/00) - Re-
move EXISTING hand brake.
A. Remove the hex bolt, washer and locknut secur-
ing the hand brake to the push handle.
B. Remove the hand brake.
INSTALLING BRAKE KIT (AFTER 3/8/00) - Re-
move EXISTING hand brake.
A. Remove EXISTING hand grip from the push
handle and discard.
NOTE: Check ALL parts for shipping damage. If shipping
damage is noted, DO NOT use. Contact Carrier/Dealer for
further instruction.
SPARTAN - 65420
1076187
Cane Kit - Left
1076188
Cane Kit - Right
1076189
Brake Kit - Left (Before 3/7/00)
1076190
Brake Kit - Right (Before 3/7/00)
1096765
Brake Kit (After 3/8/00)
SPRINT - 65400
1076192
Cane Kit - Left
1076193
Cane Kit - Right
1076194
Brake Kit - Left (Before 3/7/00)
1076195
Brake Kit - Right (Before 3/7/00)
1096767
Brake Kit (After 3/8/00)
STINGRAY - 65500
1076182
Cane Kit
1076184
Brake Kit
STARGAZER - 65600
1076183
Cane Kit
1076184
Brake Kit
Note: Cane kits contain a push handle with hand grip, and
hand brake already attached.
SAVE THESE INSTRUCTIONS
SAFETY SUMMARY
The following recommendations are made for the safe
replacement of the Rollator Canes and Brakes:
GENERAL WARNINGS
DO NOT install this kit without first reading
and understanding this instruction sheet.
If you are unable to understand the
Warnings, Cautions and Instructions, con-
tact a healthcare professional, dealer or
technical personnel if applicable before
attempting to install this kit - otherwise,
injury or damage may occur.
A physical/occupational therapist should
assist in the placement and positioning of
the hand grips for maximum support and
correct brake activation. Be sure the
rollator is properly balanced BEFORE using.
Care should be taken to ensure that ALL
hand and height adjustments are secure,
and that casters and moving objects are
in good working order before using this
or any mobility aid.
PART
NUMBER
DESCRIPTION
Rollator Cane and Brake Replacement
Assembly, Installation and Operating Instructions
1
