Invacare® Storm®⁴
1.
Release the bolts to adjust the armrest angle (1) with the allen
key.
2.
Set the angle for the armrest.
3.
Re-tighten the bolts. Make sure that the Nordlock washers used
are re-inserted.
6.4.3
Adjusting the width of the parallel sliding
armrests
The parallel sliding armrests can be adapted to the backrest in eight
widths.
Pre-requisites:
•
1 x 4 mm Allen key
1.
Undo the bolts on both sides of the backrest cover (1).
The photograph only shows the bolts on the left-hand side.
2.
Remove the backrest cover (2).
3.
On the torque support, loosen the locating pin (3) bolt (2) with
the Allen key.
4.
Reduce the load on the armrest by raising it slightly and then
remove the locating pin.
5.
Adjust the armrest width.
The possible positions for the armrest are predefined by the
drill-holes in the torque support and the armrest axel.
6.
Insert the locating pin.
7.
Retighten the screw.
34
1529686-P
