Invacare® Storm®⁴
6.7.3
Adjusting the back seat angle on the Easy-Adapt
seating system
1.
Adjust the angle by turning the handwheel (1).
6.7.4
Adjusting the height of the backrest (Modulite
seat unit)
The following section describes the procedures for adjusting the
height of the backrest plate.
NOTE
–
The sling back is only available in fixed heights of 48
and 54 cm.
Requirements:
•
1 x 5 mm Allen key
1.
Loosen the backrest plate screws
A
and
B
.
Do not remove the screws!
2.
Move the backrest plate to the required height.
3.
Re-tighten the screws.
6.7.5
Adjusting the width of the backrest (Modulite
seat unit)
You can adjust the backrest plate width to a certain degree by
adjusting the front plate, e.g. in order to adjust the backrest plate in
line with the seat cushion. Fairly large adjustments must be made by
a service technician to the rear plate and are outlined in the service
instructions for this mobility device.
40
1529686-P
