Adjusting the mobility device to the user's seating posture
Exploded drawing of seat support
1.
Remove the seat cushion.
2.
Remove the cover plates (1).
3.
Undo the two Allen screws (6) at the rear on the crossmember
and remove them.
4.
Undo the two Allen screws (9) at the front on the seat support
plate and remove them.
5.
Loosen the four Allen screws (7) and (8) which are located at the
front and back to the sides of the seat support plate to release
tension so that the plate can be moved more easily. Do not,
however, remove these screws completely.
6.
Pull or push the seat support plate (2) the required width. A
scale (3) has been fitted to the bottom part of the seat support.
Use this scale to read off the seat width in centimeters.
7.
Repeat these operations on the other side of the seat.
8.
Now tighten all the screws again.
6.13.2
Adjusting the seat depth
NOTE
–
Also refer to the previous chapter entitled 6.13.1
Adjusting seat width, page 48.
–
The seat depth can be adjusted in stages between 380
and 530 mm.
Requirements:
•
4 mm Allen key
•
8 mm jaw spanner
•
oblique pliers
•
cable binder
NOTE
–
Particular holes in the seat support must be used to
the screws depending on the required seat depth. It
may also be necessary to replace the seat support
plate.
1.
Please use the following figures and the table to determine which
holes need to be used for the required seat depth, and therefore
whether the seat support plate needs to be replaced or not.
1529686-P
49
