40
BACK ANGLE ADJUSTMENT
(FIGURE 3)
1. Remove armrests from the wheelchair. Refer to IN-
STALLING/REMOVING FLIP BACK ARMRESTS
in
PROCEDURE 4 of the owners manual, 1081227.
2. Remove the mounting screw and washer from the top
mounting hole of
back angle plate
and
back cane
.
NOTE: To avoid losing the insert in each back cane, thread
the mounting screw through the cane from the inside of
wheelchair to hold the insert in place.
TO ACHIEVE A BACK ANGLE OF:
ANGLE
BACK CANE MOUNTING HOLE
BACK ANGLE PLATE HOLE
80
O
Top
TOP Front
Bottom
BOTTOM Rear
85
O
Top
TOP Front
2nd from Bottom
BOTTOM Center
90
O
Top
TOP Front
Bottom
BOTTOM Front
95
O
Top
TOP Center
2nd from Bottom
BOTTOM Front
100
O
Top
TOP Rear
Bottom
BOTTOM Front
FIGURE 3 - BACK ANGLE ADJUSTMENT
3. Remove the mounting screw and washer from the
bottom mounting hole of the
back angle plate
and
back cane
.
4. Reposition the back canes into the correct mount-
ing holes of the
back angle plate
to obtain a back
angle between 80
o
and 100
o
in 5
o
increments.
5. Torque mounting screws to 75-inch pounds.
6. Reinstall the armrests onto the wheelchair. Refer
to INSTALLING/REMOVING FLIP BACK ARM-
RESTS
in PROCEDURE 4
of the owners manual,
1081227.
BACK FRAME
PROCEDURE 8
B
A
C
K
F
R
A
M
E
Summary of Contents for Storm Arrow
Page 105: ...105 NOTES NOTES N O T E S...
Page 106: ...106 NOTES NOTES N O T E S...
