68
R
E
C
L
I
N
E
R
PROCEDURE 14
RECLINER
FIGURE 7 - INSTALLING/REPLACING ADJUSTABLE 16
TO 19-INCH DEEP RECLINER SEAT FRAME ONTO
ARROW OR X BASE
Mounting
Screws
Base
Frame
Spacer
Recliner
Seat Assembly
Seat Mount
Plate
Locknuts
If the seat width required is within the range of the original
back canes, spreader bar and headrest pillow, the original
components can still be used.
If the seat width required is NOT within the range of the origi-
nal back canes, spreader bar and headrest pillow, the origi-
nal components can not be used.
EQUIPMENT OPTION
INSTALLING/REPLACING
ADJUSTABLE 16 TO 19-INCH DEEP
RECLINER SEAT FRAME ONTO
ARROW OR X BASE FRAME
(FIGURE 7)
1. Perform instructions outlined in PREPARATIONS FOR
REMOVING/INSTALLING SEAT FRAME (STANDARD
FRAME, ADJUSTABLE FRAME, AND CAPTAINS VAN
SEAT) in PROCEDURE 6 of this manual:
2. Perform one (1) of the following
in
PROCEDURE 7
of
this manual:
A. Remove standard seat frame subassembly. Refer
to REMOVING/INSTALLING STANDARD SEAT
FRAME SUBASSEMBLY.
B. Remove adjustable seat frame subassembly. Re-
fer to INSTALLING/REMOVING ADJUSTABLE
SEAT FRAME ASSEMBLY AND OR COMPO-
NENT REPLACEMENT.
C. Remove captains van seat. Refer to INSTALLING/
REMOVING CAPTAINS VAN SEAT ASSEMBLY.
3. Remove seat pan on recliner.
4. Install new recliner seat assembly onto seat mount plates.
5. Secure recliner seat assembly to seat mount plates with
the mounting screws, spacers and locknuts. Torque the
mounting screws to 156-inch pounds.
NOTE: There are three (3) types of seat mount plates; low,
medium, and high heights. The seat mount plate shown in
this illustration represents the medium height. Refer to
MOUNTING PLATE - SEAT ANGLE ADJUSTMENT AND
INSTALLATION ORIENTATION in PROCEDURE 6 of this
manual for illustrations of the low and high heights.
6. Position limit switch onto wheelchair. Refer to POSITION-
ING LIMIT SWITCH in this procedure of the manual.
7. Reinstall recliner seat pan with existing six (6) mount-
ing screws.
8. Install the two (2) warnings labels onto the two (2)
suspension arm assemblies. Refer to FIGURE 7
for
correct label placement.
9. Install battery box(es). Refer to INSTALLING/REMOV-
ING BATTERY BOXES- GROUP 24 BATTERY
BASE FRAMES or INSTALLING/REMOVING BAT-
TERY BOX - GROUP 22 BATTERY BASE FRAMES
in PROCEDURE 9 of this manual.
10. Perform instructions outlined in PREPARATIONS
FOR REMOVING/INSTALLING SEAT FRAME
(STANDARD FRAME, ADJUSTABLE FRAME, AND
CAPTAINS VAN SEAT) in PROCEDURE 6 of this
manual:
Warning Label
Inside of
Suspension Arm
Assembly
Summary of Contents for Storm Arrow
Page 105: ...105 NOTES NOTES N O T E S...
Page 106: ...106 NOTES NOTES N O T E S...
