Part No. 1114809
41
TDX WHEELCHAIRS
FIGURE 8 - INSTALLING/ADJUSTING
ADJUSTABLE ANGLE FLIP-UP FOOTPLATES
Nylon
Adjustment
Screw
Footplate Hinge
Footplate Hinge
Half
Clamp
Articulating
Footplate
Flat Screws
Half Clamp
Locknuts
Washers
90
o
Footrest Support
ADJUSTABLE ANGLE FLIP-UP FOOTPLATE PERPENDICULAR AND/
OR INVERSION/EVERSION ADJUSTMENT (FIGURES 8 AND 10)
NOTE: It is not necessary to remove the footplate to perform this adjustment.
1. Insert a flathead screwdriver
through the half clamp on the
articulating footplate.
2. Slowly turn nylon adjustment
screw in or out until articulat-
ing footplate is perpendicular to
the footrest assembly or the
desired inversion or eversion is
obtained.
ADJUSTABLE ANGLE FLIP-UP FOOTPLATE ANGLE ADJUSTMENT
(FIGURES 8 AND 9)
1. Loosen, but do not remove the
two (2) flat screws, washer and
locknuts that secure the
footplate to the footplate hinge.
2. Position the articulating
footplate to the necessary angle
to accommodate the user.
3. Retighten the two (2) flat
screws, washers and locknuts.
Side View Of
Footplate
and Footrest
Support.
Footrest Support
Articulating Footplate
FIGURE 9 - ADJUSTABLE ANGLE FLIP-
UP FOOTPLATE ANGLE ADJUSTMENT
FIGURE 10 - ADJUSTABLE ANGLE FLIP-
UP FOOTPLATE PERPENDICULAR AND/
OR INVERSION/EVERSION
ADJUSTMENT
Footplate
Footrest Support
Front View Of
Footplate and
Footrest Sup-
port
SECTION 4
FRONT RIGGINGS
FRONT
RIGGINGS
All manuals and user guides at all-guides.com
all-guides.com
