TDX WHEELCHAIRS
42
Part No. 1114809
COMPOSITE/ARTICULATING FOOTPLATE HEEL LOOP
REPLACEMENT (FIGURE 11)
DISASSEMBLY
Composite.
1. Remove the mounting screw and coved washer that secures the lower half of the
footrest to the swingaway footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw and locknut that secure the heel loop to the footrest.
4. Slide heel strap over cane of
footrest assembly.
Articulating.
1. Remove the two (2) mounting
screws that secure the heel
loop to the articulating
footplate.
REASSEMBLY
1. Replace heel strap/loop.
2. Reverse preceding steps to
reassemble.
NOTE: When securing heel loop to the
footrest assembly, tighten mounting
screw until the spacer is secure.
Articulating
Footplate
Mounting
Screw
Mounting Screw
FIGURE 11 - COMPOSITE/ARTICULATING
FOOTPLATE HEEL LOOP REPLACEMENT
Heel Loop
Locknut
Composite
Footplate
COMPOSITE
ARTICULATING
Spacer
INSTALLING/REMOVING ELEVATING LEGRESTS (FIGURE 12)
INSTALLING
1. Turn legrest to side (open footplate is perpendicular to wheelchair) and position
mounting holes in the legrest hinge plates with hinge pins on the wheelchair frame.
2. Install the legrest hinge plates onto the hinge pins on the wheelchair frame.
3. Rotate legrest toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3
for the opposite legrest.
5. After seated in wheelchair, adjust footplate to correct height by loosening nut and
sliding the lower footrest assembly up or down until desired height is achieved.
SECTION 4
FRONT RIGGINGS
FRONT
RIGGINGS
All manuals and user guides at all-guides.com
