TDX WHEELCHAIRS
44
Part No. 1114809
REMOVING/INSTALLING THE CENTER MOUNT
ADJUSTABLE KNEE ANGLE FOOTREST (FIGURE 14)
REMOVING
1. Remove the rigging pivot pin that
secures the footrest to the mounting
bracket of the seat frame.
2. Hold the footrest with one
hand and engage the re-
lease lever with the other
while simultaneously pulling
the center mount rigging
out of the mounting
bracket of the seat frame.
INSTALLING
1. Engage the release lever
with the one hand and hold
the center mount footrest
with the other, and insert
the center mount footrest into the mounting bracket of the seat frame.
2. Reinstall the rigging pivot pin to secure the center mount footrest to the mounting
bracket of the seat frame.
ADJUSTING HEIGHT OF THE CENTER MOUNT
ADJUSTABLE KNEE ANGLE FOOTREST
FOR ASBA SEATS (FIGURE 15)
WARNING
After adjusting the Center Mount Adjustable Knee Angle Footrest, mini-
mum ground clearance for the footrest in the driving position is 3-inches.
If the Center Mount Adjustable Angle Footrest is in the retracted posi-
tion and the chair is not moving, the footrest MUST maintain a minimum
of 1 - inch ground clearance - otherwise personal injury and damage may
result.
1. Remove the two (2) mounting screws that secure the footrest extension tube to the
extension tube housing.
2. Adjust the footrest extension tube to the desired height and align the corresponding
holes to the mounting holes on the extension tube housing.
3. Reinstall the two (2) mounting screws to secure the footrest extension tube to the
extension tube housing. Securely tighten.
4. Repeat STEPS 1-3 for the other extension tube.
SECTION 4
FRONT RIGGINGS
FRONT
RIGGINGS
Rigging
Pivot Pin
Release
Lever
Mounting Bracket
of Seat Frame
Seat Frame
Center Mount
Footrest
FIGURE 14 - REMOVING/INSTALLING THE
CENTER MOUNT ADJUSTABLE KNEE
ANGLE FOOTREST
All manuals and user guides at all-guides.com
