SECTION 6—SEAT - TDX SC ONLY
TDX® SC TDX® Spree
46
Part No 1149267
SECTION 6—SEAT - TDX SC ONLY
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, verify that ON/OFF
switch on the joystick is in the OFF position.
Removing/Installing or Tilting the Seat Assembly
Removing/Installing the Seat Assembly - Wheelchairs with Latch Bars
Only
NOTE:
For
this
procedure,
refer
to
FIGURE 6.1
on
page 47.
Removing
1. Disconnect
the
joystick
cable
at
rear
of
seat.
Refer
to
Disconnecting/Connecting
the
Joysticks
on
page 45.
NOTE:
The
latch
bar
will
be
located
behind
the
front
seat
posts
on
wheelchairs
with
adjustable
ASBA
seats
and
in
front
of
the
front
seat
posts
on
wheelchairs
with
van
seats.
2. Push
down
on
the
latch
bar
underneath
front
of
seat.
3. Rotate
seat
assembly
backward.
4. Slide
the
seat
assembly
forward
to
disengage
seat
from
pivot
brackets
located
in
the
rear.
Installing
1. Position
the
seat
in
the
rear
pivot
brackets
as
shown
in
FIGURE 6.1.
2. Rotate
seat
assembly
forward.
3. When
seat
is
lowered,
engage
seat
brackets
into
seat
clevis
pins.
WARNING
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling up on the latch bar.
4. Pull
up
on
latch
bar
to
verify
that
brackets
are
engaged
with
seat
clevis
pins.