5.
Remove the locknut
E
that secures the bracket
F
of
the POSITIVE battery cable to the POSITIVE (+) battery
post of the battery.
6.
Remove the locknut
G
that secures the NEGATIVE
battery cable
H
to the NEGATIVE (-) battery post of
the battery.
7.
Discard the existing battery per local laws and
regulations. Refer to
8.
Position battery connector bracket
I
or wiring harness
J
onto the new 22NF battery or GP24 battery as shown.
9.
Secure the NEGATIVE battery cable
H
to the NEGATIVE
(-) battery post with existing mounting screw
K
and
locknut
G
.
10. Secure the bracket
F
of the POSITIVE battery cable to
the POSITIVE (+) battery post with existing mounting
screw
L
and locknut
E
.
11. Position each battery terminal cover over top of each
battery terminal.
12. Secure battery terminal covers in place with one
tie-wrap.
13. Install batteries into wheelchair. Refer to
Installing Batteries into the Wheelchair, page 51
.
7.2.15 Cleaning Battery Terminals
WARNING!
Risk of Injury
Exposure to battery acid may result in injury.
– The use of rubber gloves is recommended
when working with batteries.
– DO NOT allow the liquid in the battery to
come in contact with skin, clothes or other
possessions. It is a form of acid and harmful or
damaging burns may result. Should the liquid
touch your skin, wash the area IMMEDIATELY
and thoroughly with cool water. In serious
cases or if eye contact is made, seek medical
attention IMMEDIATELY.
– DO NOT install/reinstall a battery with a cracked
or otherwise damaged case.
1.
Examine battery terminals for corrosion.
2.
Verify the plastic caps are in place over battery cell
holes.
3.
Clean terminals by using a battery cleaning tool, wire
brush, or medium grade sand paper.
Upon completion, areas should be shiny, not
dull.
4.
Carefully dust off all metal particles.
60101877-B
55
Summary of Contents for TDX SP2 series
Page 86: ...Notes...
Page 87: ...Notes...
