Invacare® TDX® SP2 Series
Axle loads
Maximum front axle load
•
233.7 lbs (106 kg)
Maximum rear axle load
•
213.85 lbs (97 kg)
Maximum center axle load
•
478.4 lbs (217 kg)
1
IPX4 classification means that the electrical system is protected against spray water.
IPX1 classification means that the charger is protected against vertically falling drops of water.
2
Static stability downhill, uphill, and sideways according to RESNA WC-1, Section 1 = 9° (15.8 %)
Dynamic stability uphill according to RESNA WC-2, Section 2 = 6° (10.5 %)
3
Note: The drive range of a mobility device is strongly influenced by external factors, such as the speed setting of the
wheelchair, the charging state of the batteries, surrounding temperature, local topography, road surface characteristics,
tire pressure, weight of user, drive style and use of batteries for lighting, servos etc.
The specified values are theoretical maximum achievable values measured according to RESNA WC-2, Section 4.
4
Measured with solid tires. Pneumatic tires can increase the maximum total width.
5
Measured without seat cushion
7
Horizontal distance of wheel axle from intersection of loaded seat and backrest reference planes
8
The actual curb weight depends on the options and accessories your mobility device has been supplied with. Every
Invacare mobility device is weighed when leaving the factory. Refer to the invoice for the curb weight (including
batteries) measured.
9
If two values are possible the lowest always applies.
12.2 RESNA WC-1, Section 15 Annex A
Information Disclosure in Manufacturer’s Specification
Sheets
Manufacturer: Invacare Corporation
Address: 1200 Taylor Street, Elyria, OH 44035
Model:
80
60101877-B
Summary of Contents for TDX SP2 series
Page 86: ...Notes...
Page 87: ...Notes...