5 OPERATING INSTRUCTIONS
Invacare
®
TheraPure™ Side Entry Whirlpool Tubs
24
Part No. 1167457
1.
Use the drain plug to close the drain.
2.
Remove and disassemble all jet assemblies. Lay all pieces in the bottom of the tub.
•
Rotate each jet assembly counterclockwise and pull away from the jet casing. (Detail “A”).
•
Remove each impeller cap by rotating it clockwise (Detail “B”).
•
Remove each impeller (Detail “C”).
3.
Remove the shoulder and waist straps from the mounting attachment points. Put the straps into the bottom of the tub.
4.
Clean the pieces and spray all surfaces of the tub with Dispatch® Cleaner and Disinfectant. Take a long handled brush and thoroughly clean the interior
surfaces of the tub and the jet casings.
5.
Allow the Dispatch Cleaner and Disinfectant to sit on the surfaces for one minute.
6.
Rinse all surfaces and pieces in the footwell of the tub with water.
7.
Use a clean towel to dry all tub surfaces. Allow the shoulder and waist straps to air dry.
WARNING
DO NOT put the shoulder and waist straps in the dryer, otherwise damage to the straps may occur.
Detail “A”
Detail “B”
Detail “C”
Jet Casing
Jet Assembly
Impeller Cap
Impeller
Impeller
