SECTION 7—FOOTREST/ ANTI-TIPPER
Everyday and Sport Series Wheelchairs
64
Part No 1114851
FIGURE 7.3
Replacing/Adjusting Optional A4 Footrest
Adjusting Footplate Angle
1. Loosen,
but
DO
NOT
remove
the
four
flat
screws
and
locknuts
that
secure
the
footplate
to
the
two
footrest
tubes.
2. Position
the
footplate
to
the
necessary
angle
to
accommodate
the
user.
3. Retighten
the
four
flat
screws
and
locknuts.
NOTE:
The
locknuts
should
lie
in
the
channel
of
the
footplate
half
clamp.
Adjusting Footplate Depth
1. Loosen,
but
DO
NOT
remove
the
four
flat
screws
and
locknuts
that
secure
footplate
to
the
footrest
tubes.
NOTE:
Observe
the
angle
of
footplate
for
reinstallation.
2. Move
the
footplate
to
one
of
two
positions
to
accommodate
the
user.
3. Retighten
the
four
flat
screws
and
locknuts.
NOTE:
The
settings
for
positioning
the
footplates
on
the
half
‐
clamps
may
vary
for
each
end
user.
NOTE:
The
locknuts
should
lie
in
the
channel
of
the
footplate
half
clamp.
Installing the X-Terminator Footrest
NOTE:
For
this
procedure,
refer
to
FIGURE 7.4.
1. Install
the
two
half
clamps
onto
either
side
of
the
wheelchair
frame
approximately
2
inches
above
the
existing
footrest
with
two
provided
allen
screws.
2. Repeat
for
the
opposite
side
of
the
wheelchair.
3. Slide
the
clamp
on
raised
footrest
into
the
half
clamps
to
the
desired
height.
4. Securely
tighten
the
four
allen
screws.
Allen Screws
Footrest
Tube
Flat
Screws
Footplate
Flat Screws
Angle
Depth
Height
