Part No. 1052712 Rev D
15
Terminator SS
TROUBLESHOOTING
SAFETY INSPECTION
SECTION 2
MAINTENANCE
MAINTENANCE SAFETY PRECAUTIONS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
result.
CAUTION
DO NOT overtighten hardware attaching to the frame. This could cause
damage to the frame tubing.
SUGGESTED MAINTENANCE PROCEDURES
1. Before using your wheelchair, make sure all nuts and bolts are tight. Check all parts
for damage or wear and replace. Check all parts for proper adjustment.
2. Keep quick/quad-release axles free of dirt and lint to ensure positive locking and
proper operation. Refer to ADJUSTING QUICK-RELEASE AXLES
or
ADJUSTING
QUAD-RELEASE HANDLES in SECTION 5 of this manual.
WARNING
DO NOT use WD-40®, 3-in-1 oil®, or other penetrating lubricants on
quick-release axles or camber inserts. Otherwise, binding and/or damage
to the wheelchair may occur.
3. Clean quick-release axles and camber inserts once (1) a week with a Teflon®
lubricant.
WARNING
DO NOT use your wheelchair unless it has the proper tire pressure
(p.s.i.).
DO NOT overinflate the tires. Failure to follow these suggestions may
cause the tire to explode and cause bodily harm. The recommended tire
pressure is on the sidewall of the tire.
4. Recommended tire pressure (p.s.i.) is listed on the sidewall of the tire.
SAFETY
INSPECTION
CHAIR CHAIR
SLUGGISH
CASTER SQUEAKS LOOSENESS
SOLUTIONS
VEERS VEERS
TURN OR
FLUTTERS
AND
IN CHAIR
RIGHT LEFT PERFORMANCE
RATTLES
X
X
X
X
Check tires for correct
and equal pressure.
X
X
X
X
Check for loose stem nuts.
X
X
Check spokes and nipples.
X
X
X
Check that both casters
contact the ground at the
same time.
All manuals and user guides at all-guides.com
