Terminator SS
24
Part No. 1052712 Rev D
SEAT
SECTION 4
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may result.
REPLACING TOP END SEAT UPHOLSTERY (FIGURE 1)
WARNING
The seat upholstery and/or cushion MUST be cleaned regularly and/or
replaced if incontinence is frequent. The risk of pressure sores is signifi-
cantly higher with seat upholstery that is wet and/or soiled.
1. Remove the seat cushion and back upholstery from the wheelchair.
2. Place the wheelchair onto its two (2) rear wheels.
3. Unlatch the five (5) fastening flaps that secure the seat upholstery to the wheelchair
frame.
4. Remove the existing seat upholstery.
5. Place the wheelchair back onto all four (4) wheels.
6. Install the NEW seat upholstery making
sure the five (5) fastening flaps hang
over the right and left sides of the
wheelchair frame.
NOTE: The seat upholstery MUST be posi-
tioned with the three (3) double-sided fasten-
ing flaps towards the rear of the wheelchair
for proper installation of the back upholstery.
NOTE: Make sure the rear retaining flap is
BETWEEN the wheelchair frame and the back
cane support brackets (adjustable backs only).
NOTE: Right and left is determined by sitting
in the wheelchair.
7. Insert the front fastening flaps through
the slots on the right and left sides on
the underside of the wheelchair frame
and securely latch together.
8. Place the wheelchair onto its two (2)
rear wheels.
9. Securely latch the four (4) remaining fastening flaps together.
SEAT
Section 4 - Seat - includes the following:
Replacing Top End Seat Upholstery
Replacing Custom Manual Screw On Seat Upholstery
Seat Upholstery
Wheelchair
Frame
Fastening
Flaps
Double-sided
Fastening Flaps
FIGURE 1 - REPLACING TOP END
SEAT UPHOLSTERY
All manuals and user guides at all-guides.com
