Part No. 1052712 Rev D
33
Terminator SS
WHEELS
SECTION 5
WHEELS
10. Reinstall rear wheel to the wheelchair. Refer to REMOVING/INSTALLING REAR
WHEELS in this section of the manual.
11. Adjust toe in/toe out of wheelchair. Refer to ADJUSTING TOE IN/TOE OUT in this
section of the manual.
DETERMINING TOE IN/TOE OUT (FIGURES 8 AND 9)
1. Inflate all pneumatic tires to recommended tire pressures (p.s.i.)(listed on the sidewall of the
tire).
2. Measure the distance between the centerlines at the rear and front of the rear
wheels at approximately 12-inches from the ground/floor (FIGURE 8).
NOTE: For optimum accuracy, perform STEP 2 with the wheelchair occupied.
3. Determine difference between two (2) measurements. If
difference
between the
two
(2) measurements
is
GREATER
than
1/2-inch (0 + 1/4-inch for maximum
rollability)
, one (1) of two (2) conditions exists:
A. If the
back centerline measurement
of the rear wheels is
SMALLER
than the
front centerline measurement
of the rear wheels, a
TOE-OUT
condition
exists (FIGURE 9).
B. If the
back centerline measurement
of the rear wheels is
LARGER
than the
front
centerline measurement
of the rear wheels, a
TOE-IN
condition exists (FIGURE 9).
4. If the difference between the measurements is greater than 1/2-inch, correct the
toe-in/toe-out condition. Refer to ADJUSTING TOE-IN/TOE-OUT in this section of
the manual.
12-inches
Rear of
Wheelchair
Centerlines of Rear Wheels
Front of Wheelchair
FIGURE 8 - DETERMINING TOE IN/
TOE OUT - MEASURING
CENTERLINES OF REAR WHEELS
Top View of
Wheelchair
Toe-in
Smaller Than
Front
Larger Than Front
Toe-out
Top View of
Wheelchair
FIGURE 9 - DETERMINING TOE IN/
TOE OUT - COMPARING
CENTERLINE MEASUREMENTS OF
REAR WHEELS
Front of Wheelchair
All manuals and user guides at all-guides.com
