Terminator SS
36
Part No. 1052712 Rev D
FIGURE 12 - ADJUSTING TOE IN/TOE OUT - A4 CAMBER SYSTEM - FINE
ADJUSTMENT
Adjustment Ring
Stop - In position for one
(1) camber, touching
camber clamp
Stop - Not touching
camber clamp
Adjustment Ring
Phillips Screw
Camber Clamp
Stop - Not touching
camber clamp
Adjustment Ring
Camber Clamp
Adjustment Ring
Stop - In position for one
(1) camber, touching
camber clamp
Phillips Screw
WHEELS
SECTION 5
Fine Adjustment (FIGURE 12).
NOTE: This adjustment is required any time the camber insert is repositioned.
1. Open the camber clamp. Refer to OPENING/CLOSING CLAMPS in this section of
the manual.
2. Slowly rotate the axle tube until the stop on the opposite adjustment ring is
positioned at the opposite end of the camber clamp.
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are pointing
towards the rear of the wheelchair and are in the CLOSED position BEFORE
using the wheelchair, otherwise personal injury or damage to the wheelchair
may result.
STANDARD - Make sure the hex screws and locknuts are securely
tightened BEFORE using the wheelchair, otherwise personal injury or
damage to the wheelchair may result.
3. Close the camber clamp. Refer to OPENING/CLOSING CLAMPS in this section of
the manual.
NOTE: Rear wheels removed from the drawings
for clarity, there is no need to remove rear wheels
from the wheelchair during adjustment.
NOTE: Below is one (1) example of how the
adjustment rings can be positioned.
Axle Tube - Rotates Up
and Down
WHEELS
All manuals and user guides at all-guides.com
all-guides.com
