Terminator SS
52
Part No. 1052712 Rev D
Elastomer
Fork
Bolt
Fork Stem
SUSPENSION
SECTION 7
NOTE: Caster not shown for clarity.
DETAIL B
DETAIL C
REPLACING FRONT ELASTOMERS (FIGURE 2)
WARNING
Ensure the detent ball protrudes past the fork BEFORE use. Otherwise, injury
or damage may occur.
1. Remove the bolt and locknut securing the fork to the fork stem (DETAIL "C").
2. Remove the EXISTING elastomer from the fork (DETAIL "A").
3. Position one end of the NEW elastomer into the fork stem recess and the other
end into the fork recess (DETAIL A).
NOTE: Ensure the ends of the elastomer sit flush in the fork and fork stem recesses.
4. Hold and squeeze the fork and fork stem together (DETAIL B).
5. Insert the bolt through the mounting holes in the fork to secure the elastomer to the fork.
NOTE: The bolt should be inserted from the OUTSIDE of the wheelchair, so the locknut will be on
the INSIDE of the wheelchair.
6. Install the locknut onto the bolt and securely tighten.
SUSPENSION
Bolt
Locknut
Fork
FIGURE 2 - REPLACING FRONT ELASTOMERS
Fork Stem
Fork Stem
Recess
Elastomer
Fork
Mounting Holes
Bolt
Fork Recess
(NOT SHOWN)
DETAIL A
All manuals and user guides at all-guides.com
